Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Suspension Spring ( Coil / Leaf ): Service and Repair
Mounting Bracket - Removing and Installing
Mounting bracket, removing and installing
Removing
-
Remove wheel.
-
Remove clip -1- with a pair of pliers.
Note: This clip need not be inserted again.
-
Remove nut -2-, remove both and pull both control arms out in an upward direction.
CAUTION: The slits in the swing arm/wheel bearing housing must not be widened using a chisel or similar tool.
The steering gear boot must be protected to avoid damage.
Note:
^
For clarity the illustration shows a steering gear that has been removed from the vehicle.
^
The protective sleeve -1- can be ordered, Part No. 893 512 137
-
Cut 20 - 25 mm (3/4 - 1 inch) strip, dimension A, out of the protective sleeve -1-.
-
Carefully deburr the cut surfaces.
-
Slide protective sleeve over steering gear boot with open side facing down.
-
Pull ABS wheel speed sensor wiring out of retainer on brake caliper.