Passat Syncro Wagon V6-2.8L (ATQ) (2000)
14. ATF line
^
From ATF cooler
^
Note colored markings (arrow)
15. Bolt
^
5 Nm (44 inch lbs.)
Internal Oil Line
Internal oil line, removing and installing
Special tools and equipment
^
3381 oil line installer
Removing
Remove the valve body.
-
Pry internal oil line off transmission housing using screwdriver.
Installing
-
Replace O-rings.
-
Insert internal oil line into 3381 oil line installer.
-
Using plastic hammer, knock oil line into transmission housing until tool makes contact.
^
Open side of 3381 oil line installer faces toward outside of transmission
^
Make sure that oil line is kept straight; knock both ends in evenly
-
Fill with ATF, check ATF level and top off.
-
Install the valve body.