Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
Hand-tighten bolts (arrows) securing valve body.
Bolt identified by arrow -A- is shorter than other bolts
-
Tighten bolts to specified torque, working from inside outward.
-
Press in securing clip (arrow) for harness connector on wiring harness until retaining tab engages.
-
Lubricate seal on intake neck of ATF screen with ATF, and bolt on ATF screen (arrows).
-
Install oil pan with new gasket.
-
Tighten oil pan bolts in several stages and in diagonal sequence.
-
Fill with ATF; check ATF level and top off.
Tightening torques