Passat Syncro Wagon V6-2.8L (ATQ) (2000)
Clutch Slave Cylinder: Service and Repair
Clutch release mechanism, servicing
1. Slave cylinder
After removing, do not operate clutch pedal
Installing, refer to Fig. 1
When installing, push in until the securing bolt -item 2- can be installed
Tighten bleeder valve to 4 Nm
Bleeding clutch system, refer to Service and Repair - Procedures See: Service and Repair
2. Hex socket head bolt, 20 Nm
Slave cylinder to transmission
Self-locking
Always replace
3. Bracket
For line/hose assembly
Secured to transmission with slave cylinder
4. Plunger
Coat end of plunger with copper grease
5. Dished washer
Smaller diameter (convex side) to guide sleeve
6. Input shaft oil seal
Pull out of guide sleeve with oil seal extractor lever VW 681
Knock in onto stop with fitting sleeve VW 192