Passat Syncro Wagon V6-2.8L (ATQ) (2000)
9. Locking clip
10. Master cylinder
Removing and installing, refer to See: Clutch Hydraulic System/Clutch Master Cylinder/Service and Repair
Seal -arrow- must not be removed
11. Hexagon socket head bolt, 20 Nm
12. Mounting
Insert in mounting bracket with over-center spring
Installation position: deep groove faces downward
13. Over-center spring
Remove and install with clutch pedal See: Clutch Hydraulic System/Clutch Master Cylinder/Service and Repair
14. Hex socket head bolt, 5 Nm
To secure clutch and brake pedal pivot pin
Tighten only after locking clips -item 3- and -item 9- are in position
15. Securing clip
Holds clutch switch in adjusted position
16. Torx screw, 25 Nm
Also secures the brake master cylinder with brake servo