Passat Syncro Wagon V6-2.8L (ATQ) (2000)
-
Remove intermediate mount securing nuts (arrows).
-
Measure dimension -a-.
^
Left and right-hand sides must be the same
Table of shims
-
Install securing nuts with shims for intermediate mount.
Center drive shaft longitudinally:
-
Slide drive shaft toward rear Up to stop together with assembly appliance.
-
Mark position of intermediate mount on body (arrow -A-).
-
Slide drive shaft forward up to stop together with assembly appliance.
-
Mark position of intermediate mount on body (arrow -B-).
-
Secure intermediate mount in center position (arrow -C-).
-
Remove assembly appliance.
-
Install heat shield to vehicle underbody.
-
Install rear section of exhaust system.