Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
Memory Positioning Module: Service and Repair
Memory System, Initializing
NOTE:
-
All data stored for the seat and mirror settings will be lost when the vehicle battery is disconnected.
-
This data will be retained in future control modules even after the battery has been disconnected.
-
Each new setting stored on the same button will erase the previous data.
-
It is not possible to store settings on the memory buttons if the red switch is switched-off (switch protrudes).
-
The battery voltage must not be below 10.5 V. Otherwise the system detects low voltage and will store a malfunction in the DTC memory.
The following test steps must be performed for the initialization:
-
Open driver's door.
-
Switch on ignition.
-
Then move the seat backrest forward as far as stop.
This position will be recorded for reference when the stop limit switch-off occurs.