Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
/Page-1701003.png)
-
Install inner sealing lip in cylinder grove with wedge 3409.
Note: Hold piston in front of caliper housing while performing this step.
-
Turn piston into housing by turning knurled wheel clockwise.
Note:
-
Position special tool 3272/7 between brake caliper housing and special tool 3272.
-
Position special tool 3272 so collar (arrow) of tool is seated against brake carrier
-
If piston is hard to move, use 13 mm open end wrench (arrow A).
CAUTION:
-
Use a bleeder bottle to extract part of the brake fluid from the brake fluid reservoir before pushing back the pistons
-
If this is not done, brake fluid may overflow and cause damage.
-
Install brake pads.
Pre-bleeding brake caliper
-
Open bleeder valve and using a standard bleeder bottle, fill with brake fluid until bubble-free brake fluid flows from the threaded hole (brake hose
connection). Close bleeder screw.
Note: When pre-bleeding, position brake caliper as shown in illustration.
