Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
/Page-666001.png)
Timing Belt: Diagrams
WARNING!
^
Do not re-use fasteners that are worn or deformed in normal use.
^
Some fasteners are designed to be used only once, and are unreliable and may fall if used a second time. This includes, but is not limited
to, nuts, bolts, washers, circlips and cotter pins. Always follow recommendations in this manual-replace these fasteners with new parts
where indicated, and any other time it is deemed necessary by inspection.
1- Bolt
55 Nm (41 ft lb)
2- Tensioner for ribbed belt
Secure with 3204 before removing.
See Removing and installing ribbed belt. See: Drive Belts, Mounts, Brackets and Accessories/Ribbed Belt/Service and Repair
3- Upper toothed belt guard, right
4- Toothed belt guard, center
5- Toothed belt
Mark direction of travel before removing
Check for wear
Do not kink
See Removing and installing. See: Service and Repair/Procedures
6- Upper toothed belt guard, left
7- Bolt
25 Nm (18 ft lb)
8- Bolt
25 Nm (18 ft lb)
9- Washer
10- Bearing bushing
11- Tensioning roller for toothed belt
12- Tensioning lever
13- 0-Ring
