Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
-
Used to adjust gap between clutch plate and pulley
-
Gap: 0.4 - 0.6 mm (0.015 - 0.023 in)
4
-
Circlip
-
Always replace
-
Install correctly: Thick side faces compressor.
-
Ensure correct seating in groove.
5
-
Clutch pulley
-
Remove with locally available 2 or 3 arm puller.
Ensure puller is seated correctly to prevent damage to pulley.
6
-
Circlip
-
Always replace
-
Install correctly: Flat side faces compressor.
-
Ensure correct seating in groove.
7
-
Clutch coil
-
Installing See Fig. 3
NOTE: A thermo-fuse is incorporated into the clutch coil. Current to the clutch coil is interrupted in the event of compressor overheating
(e.g. a binding compressor).
8
-
Screw
9
-
Compressor
-
Manufacturer: Denso
Fig. 1 Combination bolt for clutch plate, removing and installing
-
Remove bolt.
-
Tightening torque: 15 Nm (11 ft lb)
When removing and installing bolt, counterhold with locally available strap wrench -A-.
Fig. 2 Clutch plate, removing