Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
/Page-446001.png)
Alignment: Service and Repair
Camber
Front wheel camber, adjusting
Note: Front wheel camber cannot be set separately It is possible, however, to move the subframe in order to symmetrically center the front wheel
camber within the specified range.
-
Remove undertray.
-
Remove bolts -3- and -4-.
-
Install special tool VAG 1941.
Tightening torque of bolts -1-: 10 Nm (7 ft. lbs.)
-
Loosen bolts -1-, -2-, -5-, -6-, -7- and -8- .
-
Set front wheel camber within specified range by turning bolt -2-.
-
Relieve tension on bolt -2- and check the readings obtained, if necessary correct camber again.
Removing special tool WAG 1941
