Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
/Page-544004.png)
Note:
^
When pressing in, the thrust piece VW519 must only bear against the inner race.
^
The wheel bearing housing must remain as horizontal as possible when pressing in.
^
If the wheel bearing is tilted in the wheel bearing housing, early wheel bearing damage could occur
Fig. 10 Pressing wheel hub into 82 mm Dia wheel bearing
Note:
^
When pressing in, the thrust piece VW447i must only bear against inner race.
^
The wheel bearing housing must remain as horizontal as possible when pressing in.
^
If the wheel bearing is tilted in the wheel bearing housing, early wheel bearing damage could occur
