Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
-
Using screwdriver, carefully lift up mounting bracket (arrow).
-
Disconnect harness connector clips and remove ECM harness connectors.
-
Remove old control module and insert new one.
-
Check ECM coding, See: Engine Control Module, Coding
-
Carry out adaptation of throttle valve control module -J388- to ECM.
-
Check DTC memory of new ECM and erase DTC memory if necessary.
-
Adapt new control module module to immobilizer.
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes