Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
-
Connect multimeter between terminal 1 (B+) and 3 (Ground -GND-) for voltage measurement for the respective connector for Camshaft Position
(CMP) sensor.
-
Switch ignition on.
Specified value: at least 9.0 V
-
Switch ignition off.
If there is no voltage:
0- Connect test box to control module wiring harness, connect test box for wiring test. See: Computers and Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For Wiring
Test
-
Check wires between test box and 3-pin connector for open circuits according to wiring diagram.
Wire resistance: max: 1.5 Ohms
Vehicles with engine code AHA
Vehicles with engine code ATQ