Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
Oxygen Sensor: Service and Repair
Fuel Injection Components, Removing and Installing
Fuel injection components, removing and installing
1
-
Air cleaner
-
Disassembling and assembling, See: Fuel Delivery and Air Induction/Air Cleaner Housing/Service and Repair
2
-
20 Nm (15 ft lb)
3
-
Mass Air Flow (MAF) sensor -G70-*
-
Checking, See: Mass Air Flow Sensor/Testing and Inspection
4
-
Seal
-
Replace if damaged
5
-
Connecting hose
6
-
Motronic Engine Control Module (ECM) -J220-*
-
Location: In protective housing in plenum, left side
-
Voltage supply checking, See: Computers and Control Systems/Engine Control Module/Testing and Inspection
-
Procedure after voltage supply open circuit, See: Computers and Control Systems/Engine Control Module/Testing and Inspection
-
Removing and installing, See: Computers and Control Systems/Engine Control Module/Service and Repair
7
-
Mounting bracket
8
-
Harness connector
-
28-pin connector
-
Only disconnect or connect with ignition switched off