Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
-
40 Nm
5
-
Seatbelt guide
6
-
Concealment cap
7
-
Support for seatbelt
-
Bolted to solid backrest only; on all other versions, backrest frame is welded to support for seatbelt
8
-
Threaded plate
-
For solid backrest only; on all other versions a threaded pin is installed
9
-
Hex bolts
-
Solid backrest only
-
40 Nm
10
-
Cushion
11
-
Hex nut
-
Not with solid backrest
12
-
Hex bolt
-
Solid backrest only
-
40 Nm
Automatic Belt Retractor, Removing
Automatic Belt Retractor, Removing
-
Remove seatbench backrest.
-
Pry off cover cap - 1 - from seatbelt guide - 2 -.
-
Unscrew belt end fitting - 3 - from floor assembly (40 Nm).
-
Unclip seatbelt guide - 2 - and remove from belt - 4 -.
-
Remove cover and cushion for seatbench backrest.
-
Remove hex bolt - 1 - (40 Nm) and belt guide - 2 - from support - 3 -.
-
Remove hex nut - 5 - (40 Nm) or hex bolt (solid backrest) and unhook belt retractor - 4 - from support - 3 -.
-
Remove seatbelt with belt guide from support - 3 - downward.
NOTE: To unreel seatbelt, automatic belt retractor must be held in installation position.