Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
/Page-1773014.png)
Tip:
There is one sensing probe on each clamp, (+) and (-), make sure to check both!
^
There must be no contact between the inside connection and outside jaw of clamp -arrows-.
^
Inside connection is bent and touching outside of the clamp, -arrows-.
If clamp is incorrect:
^
Use a small flat tool and gently bend sensing probe so it does not make contact with clamp.
If this does not resolve the issue:
^
Contact Midtronics Corporation Customer Service Department at 1-800-776-1995 for assistance.
Warranty
Information only.
Required Parts and Tools
No Special Parts or Tools required.
Additional Information
All part and service references provided in this Technical Bulletin are subject to change and/or removal.
Always check with your Parts Dept. and Repair Manuals for the latest information.
