Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
Steering Column Lock: Service and Repair
Lock Cylinder, Removing and Installing
CAUTION!
-
Before beginning repairs on the electrical system:
-
Obtain the anti-theft radio security code.
-
Switch the ignition off.
-
Disconnect the battery Ground (GND) strap.
-
After reconnecting battery, re-code and check operation of anti-theft radio. Also check operation of clock and power windows.
Removing
-
Remove upper and lower steering column switch trim.
-
Insert ignition key in lock cylinder and turn to "ON" position.
-
Position 1. "OFF"
-
Position 2. "ON /DRIVE"
-
Position 3. "START"
-
Insert steel wire (approx. 1.2 mm) in drilling next to ignition key -arrow-.
-
Steering lock must be dismantled if the steel wire cannot be guided into the drilling correctly.
-
Release lock cylinder securing lever using wire -arrow- and remove lock cylinder from steering lock housing.
-
1. Lock cylinder
-
2. Wire (approx. 1.2 mm)
-
3. Securing lever
Installing
-
Insert ignition key in lock cylinder and turn to position "ON".
-
Release securing lever using wire (approx. 1.2 mm) and insert lock cylinder into steering lock housing.