Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
/Page-1963001.png)
Wheel Bearing: Service and Repair
Wheel bearing, pressing out and pressing in
1. Swing arm/wheel bearing housing
2. Wheel bearing
^
Installation position:
^
Larger internal diameter of wheel bearing faces wheel hub
^
Pressing out 75 mm Dia refer to Fig. 3
^
Pressing out 82 mm Dia refer to Fig. 4
^
Pressing bearing inner race off Fig. 5 and 6
^
Pressing in 75 mm Dia refer to Fig. 7
^
Pressing in 85 mm Dia refer to Fig. 8
3. Hub
^
Pressing out 75 mm Dia refer to Fig. 1
^
Pressing out 82 mm Dia refer to Fig. 2
^
Pressing in 75 mm Dia refer to Fig. 9
^
Pressing in 82 mm Dia refer to Fig. 10
4. Bolt
5. Splash plate
6. Wheel speed sensor
^
Pull out to remove
^
To install, coat all around with brake cylinder lube and push in by hand onto stop
7. Clamping sleeve
^
Before inserting in wheel bearing housing, coat all around with brake cylinder lube
^
Press into wheel bearing housing onto stop
Special tools required
