Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
/Page-1519001.png)
Shift Interlock Cable: Adjustments
Adjusting
-
Loosen bolt -6-.
-
Make sure it is possible to move support bracket -3- by hand in direction of arrow-5-.
-
Move steering column down and to rear.
-
Install 3352 A adjusting gauge (item -4-) between locking lever and locking cable eye.
-
To compensate for play, pull support bracket in direction of arrow -5- up to stop and tighten bolt -6- to 10 Nm (7 ft. lbs.).
-
Remove adjusting gauge.
-
Check operation of ignition key withdrawal lock after each locking cable adjustment. See: Testing and Inspection
-
Install steering column switch.
-
Install steering wheel with airbag.
-
Install center console and extension.
-
Install selector lever handle. See: Shifter A/T
-
Connect battery Ground (GND) strap.
-
Input correct coding for anti-theft radio (if equipped).
