Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
-
Remove rear final drive bearing bracket securing bolts (arrows).
-
Carefully lower rear final drive until flange is accessible.
-
Mark position of pinion securing nut with paint.
Determining dimensions -a- and -b-
a - Distance of flange to pinion
b - Distance of flange to pinion securing nut
-
Note measurements.
-
Install 3028 retainer and screw on securing nut for pinion.
Note: Reuse original nut to secure flange to pinion. Otherwise the original installation position cannot be determined again.
-
Pull off flange using VW391 puller.
-
Install two bolts -A- (M8 x 30) into flange.
-
Place drip tray underneath.