Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
Back Window Glass: Service and Repair
Undamaged Rear Window, Removing
Undamaged Rear Window, Removing
-
Disconnect harness connectors for heated rear window and press connector tabs onto window.
-
Remove auxiliary brake light.
-
Remove upper trim for trunk lid.
-
Loosen sealing lip from window flange using plastic wedge and spray in Cleaning solution D 009 401 04 (as a substitute for lubricant).
-
Using tube, insert cutting cord into window flange (cutting cable can also be used).
-
Push cutting cord through adhesive sealant into vehicle interior using Awl V.A.G 1474/2 (from Separating device for bonded windows V.A.G
1474 A).
-
Pull through outer cord end inward and counter-hold using Pulling grip V.A.G 1351/1.
-
Secure inner cord end to Spooling tool V.A.G 1654.
-
Position spooling tool V.A.G 1654.
-
Insert Protective molding foil V.A.G 1474/14 - 1 - between rear window and headliner.
-
Move Spooling tool V.A.G 1654 according to position required and cut windshield free.
-
While cutting free, press cutting cord against window using plastic wedge in order to have clearance from window flange.