Passat Syncro Wagon V6-2771cc 2.8L DOHC (AHA) (1998)
-
Using tube, insert cutting cord into window flange (cutting cable can also be used).
-
Push cutting cord through adhesive sealant into vehicle interior using Awl V.A.G 1474/2 (from Separating device for bonded windows V.A.G
1474 A).
-
Pull through outer cord end inward and counter-hold using Pulling grip V.A.G 1351/1.
-
Secure inner cord end to Spooling tool V.A.G 1654.
-
Position spooling tool V.A.G 1654.
-
Insert Protective molding foil V.A.G 1474/14 - 1 - between rear window and headliner.
-
Move Spooling tool V.A.G 1654 according to position required and cut windshield free.
-
While cutting free, press cutting cord against window using plastic wedge in order to have clearance from window flange.
Damaged Rear Window, Removing
Damaged Rear Window, Removing
-
Protect body and interior from glass splinters.
-
Remove glass pieces up to adhesive material.
-
Remove harness connectors for glass defroster and antenna.
-
Bond flange - 1 - all around with fabric reinforced adhesive tape.
-
Remove adhesive material (with glass residue) from window opening using Electric cutter V.A.G 1561 A and Knife V.A.G 1561/10 (with stopper
roll).
CAUTION: Always wear protective goggles and leather gloves.
Installing Rear Window
Installing Rear Window