Passat Wagon L4-1.9L DSL Turbo (AAZ) (1996)
Seat Belt Tensioner: Fundamentals and Basics
Front Belt Tensioning Unit, Disposal:
NOTE:
-
The unignited gas generators represent a hazard when scrapping.
-
The belt tensioner unit gas generator must be made unusable be (ore disposal This is necessary because it is a pyrotechnic device that can cause
injury if activated improperly (e.g. use of a cutting torch).
Tool For Activating Belt Tensioning Unit (Local Manufacture)
Iron Pipe:
-
Inner diameter -a- = 50 mm (1.97 in.)
-
Material thickness -b- = min. 3 mm (0.12 in.)
-
Length -c- = 2000 mm (6.6 ft)
-
Weld an iron plate on one end of the pipe.
-
Weld on a base plate so that pipe can stand upright
-
Remove seat belt with belt tensioning unit.
-
Cut through Bowden cable -1- in front of belt tensioning unit -2- with bolt cutters.
-
Dimension -a- = 100 mm (3.94 in.)
-
Pull remains of Bowden cable -4- and outer sleeve -3- off cable -2- for belt tensioning unit -1- in direction of arrow.