Passat Wagon L4-1.9L DSL Turbo (AHU) (1997)
Exhaust Pipe/Muffler Hanger: Service and Repair
LEGEND
1
From Catalytic Converter
2
Nut
3
Double Clamp
4
Intermediate Pipe
5
Clamp
6
Console
7
Mount
8
Mount Bolt/Nut
9
Rear Muffler
10
Marking
11
Separating Point
12
Separating Point
13
Dimension -b-
14
Dimension -a-
15
Marking
16
Marking
17
Connecting Pipe
18
Center Muffler
NOTE:
-
During removal and installation procedures, refer to the component location illustration above and component notes below.
-
After working on the exhaust system, ensure that the system is not under stress, and that it has sufficient clearance from the bodywork. If
necessary, loosen the double and single clamps and align the muffler and exhaust pipe so that sufficient clearance is maintained to the bodywork
and the support rings are evenly loaded.
-
Replace self-locking nuts.
COMPONENT NOTES
Nut (2)
-
Tighten to: 40 Nm (30 ft. lbs.).
Mount Bolt/Nut (8)