Passat Wagon L4-1.9L DSL Turbo (AHU) (1997)
Front Cross-Member: Diagrams
1
Hex Bolt
-
Tighten to: 5 Nm (26 ft. lbs.)
2
Ball Joint
-
Checking. See: Ball Joint/Testing and Inspection
-
Check rubber boot for damage and if necessary, replace ball joint
-
Mark installation position. If replaced set to center of elongated hole and check toe
-
Elongated holes are not for camber adjustment. Failure to observe this instruction may result in damage to drive shafts!
3
Captive Lock Nuts
4
Air Deflector Plate
-
Secured to control arm by clip
5
Control Arm
6
Control Arm Rear Mounting
7
Hex Bolt
-
12 x 1.5 x 82 mm
-
Tighten to: 50 Nm (37 ft. lbs.) and turn 90° further
8
Hex Bolt
-
12 x 1.5 x 65 mm
-
Tighten to: 70 Nm (52 ft. lbs.) and turn 90° further
9
Hex Bolt
-
12 x 1.5 x 78 mm
-
Tighten to: 70 Nm (52 ft. lbs.) and turn 90° further
10
Control Arm Front Mounting
11
Connecting Link.
-
With rubber mounting
12
Connecting Link Mounting
-
Conical side towards control arm