Passat Wagon L4-1.9L DSL Turbo (AHU) (1997)
-
If possible do not loosen when removing the rear axle
10
Hex Nut / Washer
-
Tighten to: 35 Nm (26 ft lbs)
11
Regulator Spring Bracket
12
Bonded Rubber Mounting
-
Note installation position, refer to Fig. 7
-
Pressing out, refer to Fig. 5 and 6
-
Pressing in, refer to Fig. 8
-
Only replace as pair
13
Axle Beam
-
Stub axle contact surfaces and threaded holes are to be free of paint and dirt
14
Parking brake cable bracket
NOTE: For the procedures listed below, use the tools shown in the following illustrations or their equivalents.
Fig. 1 Suspension Strut At Body, Removing And Installing
-
Removing and installing inertia reel cover, refer to Airbags and Seatbelts.
-
Inertia reel bolt (arrow) tightening torque: 40 Nm (30 ft. lbs.)
Fig. 2 Suspension Strut At Body, Removing And Installing
-
Remove and install both securing bolts (arrows) from interior of vehicle (viewed through rear left side window).
-
Tightening torque: 25 Nm (18 ft. lbs.)