Passat Wagon L4-1.9L DSL Turbo (AHU) (1997)
Fig. 8 Rubber Bonded Mounting, Pressing Axle Beam
-
Press both halves in one after the other until the mounting conical section contacts the axle beam.
Spring, Rear
NOTE: Directly below the component legend are the Fig. numbers. Please refer to these for information regarding removal and installation instructions.
1
Cap
-
Pry out with screwdriver
-
Pressing on, refer to Fig. 4
2
O-Ring
3
Self-locking hex nut
-
Tighten to: 25 Nm (18 ft. lbs.)
4
Dished Washer
5
Upper Rubber Mounting
6
Gasket (Foam)
-
Always replace
7
Suspension Strut Bearing
-
Always replace foam gasket
-
Welded nuts must be located in the spring seat recesses
-
Align welded nuts and cap to shock absorber lower bushing, refer to Fig. 3
8
Spacer Tube
9
Lower Rubber Mounting
10
Metal Cap