Passat Wagon L4-1.9L DSL Turbo (AHU) (1997)
-
Installing, refer to Fig. 3, below.
PROCEDURE
Fig. 1 Circlip (arrow), removing and installing
-
Press down carefully on piston cap until circlip can be installed.
Fig. 2 Seating of piston rings, checking
-
A piston ring is installed on the pump shaft inside the clutch housing (arrow).
-
Ensure that ends of piston rings are hooked together.
Fig. 3 Piston rings, installing and hooking ends together
-
Place piston ring in groove.
-
Press sides of ring in and guide ends over one another.
NOTE: Do not twist piston ring out of groove on one side.
Fig. 4 O-ring, installing
-
Insert O-ring in recess in turbine shaft (arrow).