Passat Wagon L4-1.9L DSL Turbo (AHU) (1997)
Shift Cable: Service and Repair
Overview
CAUTION:
^
Before working on the gear selector mechanism, disconnect the Battery Ground (GND) strap in the engine compartment
^
On vehicles equipped with an anti-theft radio, make sure you know the correct radio activation code before disconnecting the battery.
I
- Gear selector control cables.
II - Gear selector housing, removing and installing. See: Shifter M/T/Service and Repair
III - Shift lever, removing and installing. See: Shifter M/T/Service and Repair
NOTE: Before removing the gear selector mechanism, note the following:
^
Remove the Three Way Catalytic Converter (TWC)
^
Remove the heat shield
^
To replace the selector cables, first remove the complete gear selector mechanism.
^
Do not kink the selector cables.
^
Lubricate all mounting and contact surfaces MoS2 grease.
^
Gear selector mechanism, adjusting. See: Adjustments