Passat Wagon L4-1.9L DSL Turbo (AHU) (1997)
Shifter M/T: Service and Repair
Gear Selector Housing
COMPONENT NOTES AND INFORMATION
1
Shift knob
2
Collar
3
Retaining collar
4
Spring collar
-
Removing, refer to Fig. 1, below.
-
Installing, refer to Fig. 2, below.
5
Boot
-
Pull off from frame
-
Connect to shift knob before installing
6
Rubber cover with frame
-
Always remove and install together
-
After installing, install boot -5-
7
Plastic nut
-
Attaches console to gearshift housing -11-
-
Remove before removing gear selector mechanism
8
Spacer sleeve
-
Installed between console and gearshift housing -11-
9
Gasket
-
Between gearshift housing and floor
-
Self-adhesive
-
Attach to gearshift housing
10
Hex bolt
-
For mounting plate to gearshift housing
-
Tighten to: 15 Nm (11 ft lbs)
11
Gearshift housing
12
Gasket
-
Self-adhesive
-
Attach to underside of gearshift housing
13
Gasket Install between selector cables and gearshift housing
14
Center console
PROCEDURES