Passat Wagon L4-1781cc 1.8L DOHC Turbo (ATW) (2000)
Water Pump: Service and Repair
Coolant Pump, Removing and Installing
Coolant pump, removing and installing
Note:
Coolant pump is bolted to bracket for generator, power steering pump and viscous fan.
-
Lock carrier in service position See: Body and Frame/Lock Carrier/Service and Repair/Procedures/Lock Carrier And Front Bumper
Reinforcement, Moving to Service Position
Removing
CAUTION: Before disconnecting the battery:
Stop the engine.
Determine the correct coding for the anti-theft radio.
Switch the ignition off (also applies when connecting the battery). Failure to do so may damage the Engine Control Module (ECM).
-
Switch ignition off and disconnect battery Ground (GND) strap.
-
Remove ribbed belt See: Engine/Drive Belts, Mounts, Brackets and Accessories/Ribbed Belt/Service and Repair/Procedures
-
Remove viscous fan (with belt pulley) See: Radiator Cooling Fan/Fan Clutch/Service and Repair
-
Remove V-belt. See: Engine/Drive Belts, Mounts, Brackets and Accessories/Ribbed Belt/Service and Repair/Procedures
Note:
Ribbed belt for A/C compressor and torque support remains installed.
-
Drain coolant. See: Coolant/Service and Repair
-
Loosen clamps for coolant hoses -1- and -2-
-
Remove coolant hose to radiator at coolant line.
-
Remove intake air duct between intake manifold and charge air cooler.
-
Remove mounting bolts for generator.
-
Remove generator toward front.
-
Disconnect wiring from removed generator.