Passat Wagon L4-1781cc 1.8L DOHC Turbo (ATW) (2000)
Crankshaft: Service and Repair
Crankshaft, removing and installing
Note: Secure engine to holding fixture VW 540 on assembly stand when disassembling/assembling engine.
1. Bearing shells 1, 2, 4 and 5
^
For bearing cap without oil groove
^
For cylinder block with oil groove
^
Do not interchange used bearing shells (mark)
2. 65 Nm + 90° (1/4 turn) further
^
Always replace
^
Threaded along complete length (screw)
^
Tighten to 65 Nm when measuring radial clearance
3. Bearing cap
^
Bearing cap 1: Pulley end
^
Bearing shell retaining lugs (cylinder block/bearing cap) must be on the same side
4. Bearing shell 3
^
For bearing cap without oil groove
^
For cylinder block with oil groove
^
Do not interchange used bearing shells (mark)
5. Thrust washer
^
For bearing 3 bearing cap
^
Note installation
6. Sensor wheel
^
Always replace
^
For Engine Speed (RPM) sensor -G28-