Passat Wagon L4-1781cc 1.8L DOHC Turbo (ATW) (2000)
-
Clean groove before check.
Fig. 3 Checking piston
-
Measure pistons approx. 10 mm from lower edge of skirt, at 90° to piston pin axis.
^
Deviation from nominal dimension: max. 0.04 mm
Fig. 4 Checking cylinder bores
-
Measure bores at 3 locations in both directions -A- across engine and -B- in line with crankshaft. Use internal dial gauge 50 to 100 mm.
^
Deviation from nominal dimension: max. 0.08 mm
Note: Measuring the cylinder bores must not be done when the cylinder block is mounted on a repair stand with holding fixture VW 540, as incorrect
measurements would then be possible.