Passat Wagon L4-1781cc 1.8L DOHC Turbo (ATW) (2000)
Maintenance Required Lamp/Indicator: Service and Repair
Service Reminder Indicator (SRI), Resetting (Adaptation)
Adaptation (function 10)
Using the adaptation function, the following changes can be made and saved.
-
Adaptation of Service Reminder Indicator (SRI)
-
Adaptation of odometer for replacement of instrument cluster
-
Resetting Service Reminder indicator (SRI)
-
Adaptation of fuel gauge
-
Correcting fuel consumption indicator
-
Coding of language version for indicator unit for navigation (only for Midline and Highline instrument clusters)
-
Coding of diagnostic interface for CAN-bus
Individual functions are called up by entering the appropriate adaptation channel numbers (listed in the adaptation table).
Adaptation table:
Adaptation channel Adaptation function
02
Resetting Service Reminder Indicator (SRI)
04
Language versions for driver instructions (only for Highline and Midline instrument clusters)
09
Adaptation of odometer
10
Service interval data for oil service (OIL) trip counter
11
Service interval data for inspection (INSP) - trip counter
12
Service interval data for inspection (INSP) - counter for time in 10 day intervals
30
Adaptation of fuel gauge
40
Service interval data - counter for distance travelled since last inspection
41
Service interval data counter for time since last inspection
42
Service interval data lower limit for distance travelled until inspection
43
Service interval data upper limit for distance travelled until inspection
44
Service interval data upper limit for time until inspection
45
Service interval data value for oil quality for flexible service intervals
46
Service interval data for total fuel consumption quantity in liters/cylinder, only for gas engines (transmitted by Engine Control
Module -ECM-)
47
Service interval data for carbon quantity (only diesel engines, transmitted by Engine Control Module -ECM-)
48
Service interval data for oil wear (only diesel engines, transmitted by Engine Control Module -ECM-)
NOTE: After changing an adaptation value or ending an adaptation channel, "Adaptation " function 10 must be performed again before selecting another
adaptation channel.
Service Reminder Indicator (SRI), resetting
NOTE: The Service Reminder Indicator (SRI) must be reset (adapted) for:
-
vehicle release inspection
-
every service
The Service Reminder Indicator (SRI) can be reset in two different ways:
-
using the adjustment button for odometer and clock at instrument cluster
or, as described below,
-
Using VAG 1551 Scan Tool (ST)
-
Connect VAG 1551 Scan Tool (ST), select operating mode 1 "Rapid data transfer", switch ignition on and enter address word 17 for "instrument
cluster".
After control module identification is displayed:
-
Press -> button.
Indicated on display:
Rapid data transfer
HELP
Select function XX