Passat Wagon L4-1781cc 1.8L DOHC Turbo (ATW) (2000)
-
Inspect center fuel line to ensure flare joint is positioned to the right and outside of bracket
-
If flare joint is visible outside of bracket approximately 1mm to the right, work is complete
-
If flare joint is not visible outside of bracket approximately 1mm to the right, proceed to Section C
Section C - Fuel Line Foam Block Removal and Bracket Clipping
(2001-2005 1.8T vehicles)
-
Remove air filter housing
-
Remove and discard insulating foam -circle- located below air filter housing
-
Close connector at rear wall
-
Check to see if flare joint is now visible outside bracket
-
If not visible outside bracket, carefully pull fuel line to the right to move flare joint outside of bracket
-
Close bracket near air filter