Passat Wagon L4-1781cc 1.8L DOHC Turbo (ATW) (2000)
^
With spring supporting body and compression springs
12. Piston
^
Sealing lips are vulcanized to piston
^
Moisten sealing lips with ATF before installing
^
Turn piston slightly when installing
13. Clutch housing
^
Before inserting inner plate carrier corrugated washer (item 8), insert inner and outer plates in the clutch; see Fig. 3
Fig. 1 Circlip, removing and installing
-
Press piston cap with intermediate spring ring down far enough for circlip (arrow) to lock in groove.
Fig. 2 Thrust plate and plates on inner plate carrier, installing
-
Install thrust plate -a- with smooth side facing inner plate and stepped side toward inner plate carrier.
-
Install 3 inner plates -b- and 2 outer plates -c-.
-
Clip in supporting ring with step (arrow).
^
Locate lugs correctly.
^
Installing corrugated washer and additional plates in clutch housing; see Fig. 3.
Fig. 3 Installing
-
First insert corrugated spring washer.
-
Install 2 mm (0.078 inch) thick outer plate.
-
Install remaining inner and outer plates.