Passat Wagon L4-2.0L (ABA) (1995)
Water Pump: Service and Repair
Coolant Pump Disassembling and Assembling
Coolant Pump Disassembly and Assembly
Note:
During disassembly and assembly procedures, refer to the component location illustration and component notes below.
1
Bolt. Torque Specification: 25 Nm (18 ft. lbs.).
2
Pulley - Ribbed Drive Belt version.
3
Engine Coolant Pump (Water Pump) - Check shaft for ease of movement.
4
Gasket - Always replace.
5
Coolant Thermostat - Checking: Heat-up thermostat in boiling water.
Starts to open at approx: 87°C (188°F).
Fully open at approx: 102°C (215°F).
Opening lift: 7 mm (0.28 inch) minimum.
6
Elbow Connection
7
O-ring - Always replace.
8
Retaining Clip
9
Bolt. Torque Specification: 10 Nm (7 ft. lbs.).
10
Thermostat Flange
11
Pulley - V belt version.