Passat Wagon L4-2.0L (ABA) (1995)
Engine Mount: Service and Repair
Engine Mount Rubber Bushing, Replacing
Engine mount rubber bushing, replacing
-
Install engine holding fixture 10-222A with supports 10-222A/1.
-
Connect engine sling in hook eye on cylinder head (left side) and tighten to lift engine slightly.
-
Remove engine mount.
-
Pry spacer -2- from rubber mount bushing.
-
Remove rubber mount bushing -1-.
Take notice of rubber mount bushing -1- installation position.
-
Install new rubber mount bushing.
-
Press engine mount spacer into rubber mount bushings.
-
Install engine mount -4- and tighten bolts -3-.
Tightening torque: 80 Nm (59 ft lb)