Passat Wagon L4-2.0L (ABA) (1995)
Wipe away excess grease completely
No grease must get into the oil circulation system
Coat piston of toothed rod and protective tube with hydraulic oil
Install installation sleeve tool No. 3315/21, or equivalent, into the housing
Slide toothed rod into the housing
When sliding, make sure that the sealing ring is pressed into the groove of the piston without jamming
Slowly introduce the toothed rod into the housing
Pull protective tube 3315/5 off the toothed rod
Align teeth of toothed rod in such a way that they point toward the teeth of the pinion
Screw mounting sleeve tool No. 3315/16, or equivalent, on toothed rod and coat with hydraulic oil
Carefully slide toothed rod guide rod into the housing to stop
Slide toothed rod completely into housing if not done yet
1
toothed rod guide
Install circlip in such a way that the opening of the ring is opposite the groove in the housing
Valve Body, Installing
Drive roller bearing in to stop with tool No. VW 421, or equivalent. Roller bearing must not be tipped when driving in.