Passat Wagon L4-2.0L (ABA) (1995)
-
12 x 1.5 x 78 mm
-
Tighten to: 70 Nm (52 ft. lbs.) and turn 90° further
10
Control Arm Front Mounting
-
Pressing out, refer to Fig. 1
-
Pressing in, refer to Fig. 2
11
Connecting Link.
-
With rubber mounting
12
Connecting Link Mounting
-
Conical side towards control arm
13
Washer
-
Collar faces away from mounting
14
Self-Locking Hex Nut
-
Tighten to: 25 Nm (18 ft. lbs.)
15
Subframe
-
Removing and installing with assemblies installed: supporting assemblies, refer to Fig. 5
-
Remove sub-frame from below with support tool No. VAG 1383, or equivalent, (with control arm but without steering gear).
-
After installing check position of steering wheel and align front end.
-
Aligning engine-transmission assembly, refer to Engine
16
Hex Bolt
-
Tighten to: 65 Nm (48 ft. lbs.)
17
Stabilizer Bar Mounting
18
Stabilizer Bar
19
Stabilizer Bar Clamp
20
Hex Bolt
-
Tighten to: 25 Nm (18 ft. lbs.)
-
To secure stabilizer bar
21
Vibration Damper
-
Note installation position, large part must protrude from sub-frame
22
Self-Locking Hex Nut,
-
Tighten to: 25 Nm (18 ft. lbs.)
23
Cap Nut
-
Repairing in side, refer to Repair Cap Nut In Side Member.
NOTE: For this procedure, use the tools shown in the following illustrations or their equivalents.
Fig. 1 - Front Wishbone Mounting, Pressing Out