Passat Wagon L4-2.0L (ABA) (1995)
-
With spring supporting shell and compression springs
12
Piston
-
Sealing lips are vulcanized to piston
-
Moisten sealing lips with ATF before installing
-
Turn piston slightly when installing
13
Clutch housing
-
Before installing the inner plate carrier corrugated washer (item 8), install inner and outer plates in the clutch, refer to Fig. 3
PROCEDURES
Fig. 1 Circlip, removing and installing
-
Press piston cap with intermediate spring ring down far enough for circlip [arrow) to be inserted in groove.
Fig. 2 Thrust plate and plates, installing on inner plate carrier
-
Install thrust plate -a- with smooth side facing inner plate and stepped side toward inner plate carrier.
-
Install 3 inner plates -b- and 2 outer plates -c-.
-
Clip in supporting ring with step (arrow).
NOTE:
^
Position locating lugs correctly.
^
Installing corrugated washer and further plates in clutch housing, refer to Fig. 3, below.
Fig. 3 Corrugated washer and inner and outer plates, installing in clutch housing
-
Install corrugated washer.
-
Install 2 mm thick outer plate.
-
Install remaining inner and outer plates.