Passat Wagon L4-2.0L Turbo (BPY) (2008)
Hood Stop: Adjustments
Hood Adjusting Buffer, Adjusting
NOTE: The following adjustment is only for the left adjustment buffer. Adjustment for the right adjustment buffer is derived accordingly from this.
-
Loosen clamping screw - 1 - far enough until it is visible in rubber buffer.
-
Now pull notched slider - 2 - out of adjustment buffer.
-
Set notched slider to dimension - a - = 12.5 mm.
-
Close hood to initial locking position using light pressure over the center.
-
Open hood again.
-
Screw in clamping screw - 1 - for adjustment buffer to a depth of dimension - a - = 25 mm.
-
Check the adjustment.