Passat Wagon L4-2.0L Turbo (BPY) (2008)
/Page-970003.png)
Specified value: at least 4.5 V
-
Switch the ignition off.
If the specification was not obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to => [ Motronic Engine Control Module J623, Replacing ] See: Engine
Control Module/Service and Repair/Motronic Engine Control Module J623, Replacing.
-
Using a Multimeter, check the Throttle Valve Control Module (J338) electrical harness connector terminals to the Motronic Engine Control
Module (ECM) (J623) electrical harness connector T60 terminals for resistance.
