Passat Wagon L4-2.0L Turbo (BPY) (2008)
/Page-1061002.png)
Specified value: 12.0 to 20.0 ohms (at approx. 20° C)
If the specified value was not obtained:
-
Replace the malfunctioning Fuel Injector.
If the specified value was obtained:
Checking activation
-
Connect a diode test lamp (12V) to the electrical harness connector terminals 1 and 2 of the Fuel Injector to be tested.
-
Operate the starter and test the activation of the Fuel Injector.
LED should flicker.
-
Switch the ignition off.
If LED does not flicker:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to => [ Motronic Engine Control Module J623, Replacing ] See: Computers
