Passat Wagon L4-2.0L Turbo (BPY) (2008)
/Page-845002.png)
-
Shift transmission to position "P" using lever - 3 -, i.e. push lever - 3 - rearward against direction of travel until stop.
-
Shift transmission to position "N" using lever - 3 -. To do so, press lever - 3 - two latched positions toward front in direction of travel.
-
Install spring washer - 2 - and nut - 1 - on shift rod - 4 -.
-
Tighten nut - 1 - to 13 Nm.
Vehicles with 6 cyl. gasoline engine
-
Install engine coolant expansion tank.
-
Disconnect battery Ground (GND) cable with ignition switched off.
Continued for all vehicles
-
Check shift mechanism => [ General Repair Information ] See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and
Repair/Procedures/General Repair Information.
