Passat Wagon L4-2.0L Turbo (BPY) (2008)
Seals and Gaskets: Service and Repair
6 SPD. Automatic Transmission 09G Front Wheel Drive
Selector Shaft Seal
6 SPD. A/T 09G FWD
Selector Shaft Seal
Special tools, testers and auxiliary items required
^
Thrust piece T10174
-
Remove Multi-Function Transmission Range (TR) Switch F125.
-
Carefully pry out shift rod gasket using screwdriver. Do not damage shift rod while doing so.
-
Drive in new gasket until stop using thrust piece T10174 - -, do not cant while doing so.
-
Adjust Multi-Function Transmission Range (TR) Switch F125.
Flange Shaft Seal
6 SPD. A/T 09G FWD
Flange Shaft Seal
Special tools, testers and auxiliary items required
^
Drip tray V.A.G. 1306
^
Puller T10055
^
Thrust piece T10176
Flange Shaft Seal, Removing
(Transmission in vehicle)
Only left side is described here. Replacing oil seal for right side is almost the same.
-
On the right, drive axle remains in wheel bearing, use the thrust piece T10177, on the left side, remove drive axle and use the thrust piece T10176.
-
Remove noise insulation.
-
Place drip tray V.A.G. 1306 underneath.