Passat Wagon L4-2.0L Turbo (CCTA) (2009)
7
Coolant pump
‹› Removing and installing => [ Coolant Pump, Removing and Installing ] See: Coolant Pump, Removing and Installing
‹› with a new coolant pump, remove the protective cap
8
Gasket
‹› Replace
9
Centering pins
10
Toothed belt
‹› For coolant pump
‹› Removing and installing => [ Coolant Pump Toothed Belt, Removing and Installing ] See: Coolant Pump Toothed Belt, Removing and
Installing
11
Toothed belt cover
12
Bolt
‹› 9 Nm
13
Bolt
‹› Left thread
‹› Replace
‹› 10 Nm + 90° (1/4) turn.
14
Drive gear for toothed belt
‹› Installation position: The collar on the drive gear faces the transmission.
15
Shaft seal
‹› replacing => [ Coolant Pump Drive Shaft Seal, Removing and Installing ] See: Coolant Pump Drive Shaft Seal, Removing and Installing.
16
Balance shaft
17
Coolant thermostat
‹› Removing and installing => [ Coolant Thermostat, Removing and Installing ] See: Thermostat/Service and Repair/Coolant Thermostat,
Removing and Installing
18
Centering pin
19
Connecting piece
20
Bolt
‹› 9 Nm
21
O-ring
‹› Replace
Coolant Pump, Tightening Sequence