Passat Wagon L4-2.0L Turbo (CCTA) (2009)
/Page-2012001.png)
Horn: Service and Repair
Horns
‹› High Tone Horn (H2) and Low Tone Horn (H7) are activated in parallel by Vehicle Electrical System Control Module (J519).
‹› Removal and installation procedure for both horns is the same.
‹› High Tone Horn (H2) is installed at left and Low Tone Horn (H7) is installed at right, next to radiator.
Removing:
-
Turn off the ignition and all electrical consumers.
-
Remove noise insulation.
-
Disconnect electrical connection - 2 -.
-
Remove the mounting bolt - 1 - and remove signal horn - 3 - with bracket.
Installing:
-
Install in reverse order of removal, noting the following:
-
Tighten the fasteners to the specification shown in => [ Specifications ] See: Specifications/Table of Contents.
