Passat Wagon 4Motion V6-2.8L (ATQ) (2003)
/Page-2127006.png)
-
Hole -1-, sub-frame hole -2- and aluminum console hole -3- must align on both sides.
Note: This attachment only replaces subsequent axle alignment measurements when:
-
The sub-frame is removed completely and installed.
-
Holes -1- and -2- align before repairs are made.
-
Tighten bolts -1- and -2- at rear of subframe on both sides of vehicle.
A - Block of wood
-
Protect holes in body for mounting special tool 3393 against corrosion.
-
Tighten hex bolts -A- and -B.
-
Tighten hex bolts -arrows- at transmission mounting -1-.
